Aeromotive 18688 - PHANTOM 340 STEALTH FUEL SYSTEM - Manual (Page 4)

The following steps are typical of most installations:
1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel system
pressure, referring to the appropriate vehicle service manual for the procedure and precautions for doing so.
2. Raise the vehicle on stable level ground and support it with jack stands.
3. Referring to the appropriate vehicle service manual for instructions, drain, disconnect any electrical and fuel
component connections and remove the OEM fuel tank. The removal of the vehicles exhaust system may be
necessary for fuel tank removal.
This Aeromotive Phantom Fuel Pump System is intended to be installed into a
NEW fuel tank that does NOT , and has NEVER contained fuel.
If you choose to install this product into a fuel tank that has had fuel introduced
to it, proceed at your own risk.
The fuel tank must be professionally cleaned to remove all traces of any
combustible fluids. Failure to properly clean and remove all combustible fluids
from the fuel tank will result in injury or loss of life to yourself and/or others.
4. With the new cleaned fuel tank on your preferred work surface, start to determine the desired pump mounting
location on top of the fuel tank by identify mounting areas to avoid. Avoid areas of the tank where level sending unit,
float arm or float are present. Also, avoid areas where the fuel filler neck may protrude inside the fuel tank.
Never mount the fuel pump on the side or bottom of the fuel tank.