Aeromotive 17130 - 86-98.5 A1000 5.0L MUSTANG STEALTH FUEL SYSTEM - Manual (Page 6)

1-17. Locate the 10-gauge red wire connected to the pump in step 1-11 and route it to the new fuel pump relay in a
manner that protects it from existing exhaust and suspension components.
1-18. Cut the red 10-gauge wire from the fuel pump to the proper length to reach the relay and terminate it with the yellow
female spade connecter provided. Then, connect the red wire to terminal number 87 on the relay.
1-19. Locate and route the black 10-gauge wire from the fuel pump to a good ground. Use the battery ground post, the
chassis end of the battery ground cable, or a solid, clean chassis ground on the frame (not to sheet metal). Cut the
black 10-gauge wire from the fuel pump long enough to reach the chosen ground point and install the appropriate
yellow ring connector. Now connect the fuel pump ground wire securely to the grounding point.
1-20. Route the 10-gauge red wire provided from the chosen 12VDC supply point chosen in step 1-15. Connect 12VDC
from the battery (+) post or the alternator charging stud to the remaining stud on the circuit breaker using the supplied
10-ga red wire with one of the yellow #10 ring connectors on the circuit breaker end and the yellow 3/8” ring connector
on the battery or alternator end.
1-21. Ensure that electrical components and wires are connected properly (See FIGURE 1-6) and are clear of any moving
suspension or drivetrain components and any exhaust components! IMPORTANT: Route wires carefully to protect
them from damage due to abrasion and road obstructions or debris.
FIGURE 1-6
1-22. Position the new Aeromotive Stealth Tank under the rear of the car and connect the fuel level sending unit wires to
the terminal studs on the top hat.
1-23. With the fuel tank in position, align the tank mounting straps and lift the tank into position, ensuring that none of the
fuel lines or wiring will be pinched between the tank and the underside of the trunk, install and tighten the strap bolts.
1-24. Make any line or electrical wire routing adjustments necessary to clear the vehicles exhaust, suspension, and
drivetrain components..