Aeromotive 17130 - 86-98.5 A1000 5.0L MUSTANG STEALTH FUEL SYSTEM - Manual (Page 4)

1-7. Before placing the fuel level sender assembly in the tank, attach the two level sending unit wires on the Stealth pump
to the fuel level sender assembly. Using the red solder/splice and a heat gun or small butane torch, connect and
solder/shrink wrap one of the wires from the fuel pump to the wire on the sending unit itself and mark the
corresponding terminal on the outside of the pump with a black marker or masking tape. Next, crimp the provided
ring connector on the remaining wire and attach the ring connector to the bracket with the self-tapping screw.
See FIGURE 1-3
FIGURE 1-3
1-8. With the pump resting on top of the fuel tank, position the fuel level sender assembly into the tank as shown in
FIGURE 1-4 With the fuel level sender bracket and the baffle walls butted up against each other. Push the provided
edge clips into position to secure the fuel level sending unit bracket to the top of the baffle inlet wall.
FIGURE 1-4