Aeromotive 17130 - 86-98.5 A1000 5.0L MUSTANG STEALTH FUEL SYSTEM - Manual (Page 10)

3-8. In the vehicle’s engine compartment, find a suitable location near the fuel rails for the supplied Y-Block.
3-9. Starting from the fuel rails, plan a route to run an AN-06 supply line from each fuel rail on the firewall end to each side
of the Y-block, see FIGURE 3-3. Cut the two supply lines to the determined length and install two straight AN-06 hose-
ends on the Y-block end of each line, and two 90-deg. AN-06 hose-ends on the fuel rail end of each line, as detailed in
Section 4.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
3-10. Using the above steel braided hose assemblies, connect one end to the Y-block and the other end to the fuel rails,
as shown in FIGURE 3-3, and tighten.
FIGURE 3-3
3-11. Starting from the outlet of the fuel pump / filter assembly, plan a route to run an AN-08 supply line from fuel pump /
filter assembly to the Y-block. This line should be run along the same route you planned to run the return line in step
1.24. Cut the supply line to the determined length and install the AN-08 hose-ends, as detailed in Section 4.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
3-12. Using the above steel braided hose assembly, connect one end to the outlet of the fuel pump / filter assembly.
Keeping both the supply line and return line from the Aeromotive fuel tank together, secure both lines to the vehicle
along the predetermined route using the supplied tie-wraps and cushion clamps. Once both lines are to there
destination, the supply line to the Y-block and the return line to the bottom of the regulator and tighten.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
3-13. Once the regulator is installed, attach the supplied fuel pressure gauge to the 1/8 NPT port on the fuel pressure
regulator (keep port to re-install after pressure is set).