Aeromotive 17135 - TSUNAMI EFI FUEL SYSTEM User Manual
Page 7
2-7. Due to the great diversity in fuel system requirements, your Aeromotive fuel system kit only provides accommodations
for one supply line, it is recommended that for multiple fuel rail configurations you split the supply line into separate
lines using a Y-block and feed each rail independently. Call Aeromotive for details.
2-8. Starting from the fuel rails, plan a route to run an AN-06 supply line from the fuel rail(s) to the fuel pump/filter
assembly. Cut the supply line(s) to the determined length and install the AN-06 hose ends, as detailed in Section 3.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
2-9. Using the above steel braided hose assemblies, connect the system together as shown below and tighten.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
2-10. Once the regulator is installed, attach a suitable fuel pressure gauge (not supplied) to the 1/8 NPT port on the fuel
pressure regulator.
Parts shown in
cloud are not
included in this
kit.
AN-06 port plug
not included in kit