Aeromotive 17135 - TSUNAMI EFI FUEL SYSTEM User Manual
Page 2
The following steps are typical of most installations:
Section 1 - Fuel Pump Installation
Section 2 – Fuel Regulator Installation and Fuel Line Plumbing
Section 3 – Fuel Line Hose End Installation
Section 4 – Electrical Installation
Section 5 – Final Checks and System Start-up
Fuel Pump Template
Typical hose end to fitting connection:
Typical o-ring sealed port connection:
Hose End
Connect hose end to 37-degree flare side of union.
Do not connect hose end to cutoff side of union!
O-ring sealed AN style port
O-ring
(Install on union fitting between back of
threads and face of hex nut.)
Typically the cutoff side of the union is used as
the o-ring sealed side, leaving the 37-degree
flare side for your hose end connection. In some
cases both sides of the union utilize an o-ring
seal. For example, in this kit a union connects
the port of the fuel pump and filter.