Aeromotive 17135 - TSUNAMI EFI FUEL SYSTEM - Manual (Page 6)

Section 2 – Fuel Regulator Installation and Fuel Line Plumbing
2-1. In the vehicle’s engine compartment, mount the supplied fuel pressure regulator in the location established in step 1-
15. Using the supplied mounting bracket as a template, mark the bracket mounting holes and drill to accept a #10
screw.
2-2. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two #10 screws, nuts
and lock washers (not provided).
2-3. Install two of the supplied AN-06 o-rings on the cutoff side of two AN-06 cutoff union fittings and install in each of the
AN-06 ports located on the sides of the supplied fuel pressure regulator. If you have a single fuel rail system, plug one
of the ports using an AN-06 port plug (not provided) and o-ring.
2-4. Install one of the supplied AN-06 o-rings on the cutoff side of the AN-06 cutoff union fitting and install in the AN-06
port located on the bottom of the supplied fuel pressure regulator.
2-5. Starting from the fuel rails, plan a route to run an AN-06 feed line from each fuel rail to each side of the regulator. In
the case of a single fuel rail system, only run one line from the fuel rail to the regulator. Cut the two supply line(s) to
the determined length and install the AN-06 hose ends, as detailed in Section 3.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
2-6. Using the above steel braided hose assemblies, connect the side(s) of the fuel pressure regulator and the other end
to the fuel rail(s) and tighten.