Aeromotive 17135 - TSUNAMI EFI FUEL SYSTEM User Manual
Page 5
1-14. Using the above steel braided hose assembly, connect one end to the outlet of the fuel tank sump and the other
end to the fuel pump / filter assembly inlet and tighten.
Note: It is recommended that a fuel shut off valve be installed between the fuel tank outlet and the fuel pump /
filter assembly inlet, these valves are available from most popular racing fitting manufactures; Aeroquip,
Earl’s, Goodridge, Russell, etc.
1-15. In vehicles engine compartment, locate a suitable mounting location for the supplied fuel pressure regulator
1-16. Starting from the determined regulator mounting location in the engine compartment, plan a route to run an AN-06
return line back to the fuel tank or fuel cell return port and measure the required length. Cut the return line to the
determined length and install the two supplied AN-06 straight hose ends, as detailed in Section 3.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
1-17. Thread one end of the AN-06 return line onto the AN-06 return line accommodations of your fuel tank or fuel cell
and tighten.
1-18. Make any line or electrical adjustments necessary to clear the vehicles exhaust, suspension, and drivetrain
components.