Aeromotive 17135 - TSUNAMI EFI FUEL SYSTEM User Manual
Page 4
1-7. Install one of the supplied AN-10 o-rings on the cutoff side of the AN-10 to AN-08 reducer fitting and install on the inlet
side of the pump / filter assembly.
1-8. Install one of the supplied AN-10 o-rings on the AN-10 cutoff side of the AN-10 to AN-06 reducer union fitting, and
install the fitting on the outlet side of the pump / filter assembly.
1-9. Find a suitable mounting location for the above pump / filter assembly. Typical mounting locations include mounting
the fuel pump to the fuel tank shield or mounting to the inside of the frame rail. The fuel pump should be mounted as
close to the fuel tank as possible and as low as possible. Using the fuel pump mounting clamps as a guide, mark the
four pump mounting holes. Ensure there are no obstructions behind the mounting surface and drill four ¼” mounting
holes.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
1-10. If you are using the plastic fuel tank shield for mounting your fuel pump, secure the fuel pump to the plastic fuel
tank shield by installing four ¼” carriage bolts (not included) from the inside of the fuel tank shield, through the fuel
tank shield and through the fuel pump mounting holes. Install four flat washers and nuts on the bolts and tighten.
Inspect the inside of the plastic fuel tank shield for any sharp edges that could puncture the fuel tank. If any sharp
edges are found, correct before proceeding.
1-11. If you are mounting the fuel pump in some other fashion, secure the fuel pump to the mounting surface using four
¼” bolts, nuts, and lock washers (not provided).
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
1-12. Using the two supplied AN-08 hose ends as a guide, measure the length of AN-08 steel braided line needed to
connect your fuel tank sump or fuel cell outlet to the fuel pump / filter assembly inlet.
1-13. Cut and assemble the steel braided hose and hose ends as shown in Section 3.