Aeromotive 14135 - 04-06 SUBARU 2.0L WRX FUEL RAIL SYSTEM User Manual
Page 11
45. Refill engine coolant and check system for leaks.
46. Reconnect the battery and turn the ignition to the ON position WITHOUT starting the
car. After several second turn the ignition key to the OFF position, wait one minute.
Repeat this process until you pressurize the fuel system.
47. Adjust the fuel pressure regulator to the desired fuel pressure (Factory setting with no
vacuum is 42 psig). Once the fuel pressure gauge registers the desired fuel system
pressure and there are no fuel leaks, start the engine.
48. With fuel pressure in the system, check for leaks from and around all the fuel system
components and all fuel lines and connections. If any fuel leaks are found, turn the
ignition key to the OFF position, remove any spilled gasoline and repair the leak before
proceeding.
49. Once the fuel system has been confirmed to be leak free, test drive the vehicle to insure
proper operation and re-check the fuel and coolant systems for leaks. If any leaks are
found, immediately shutoff the engine and repair the leak(s)