AAEON EPIC-CV01 Series - Manual (Page 26)

EPC-CV1 Series 2-18
10. USB 2.0 connector (10-pin USB1)
This connector is for USB 2.0 ports. Connect the USB module cable to
this connector, then install the module to a slot opening at the back of the
system chassis. This USB connector complies with USB 2.0 specification that
supports up to 480 Mbps connection speed.
CAUTION! Never connect a 1394 cable to the USB connector. Doing so will
damage the motherboard!
NOTE: The USB module cable is purchased separately.
EPC-CV1 Series USB 2.0 connector
PIN 1
GND
GND
USB5+_R
USB5-_R
+5V +5V
USB4-_R
USB4+_R
GND
GND
USB1
11. SPI programming connector (8-pin SPI1)
Use this connector to flash BIOS SPI ROM.
EPC-CV1 Series SPI programming connector
PIN 1
SPI1
GND SPI_CLK SPI_MOSI (NC)
+V3.3SPI SPI_CS# SPI_MISO
(NC)