Elmo Rietschle L-BV5 Operating instructions - Manual (Page 14)

Installation
610.44440.40.000 14 / 32 © Gardner Denver Deutschland GmbH
Transport of type 2BV5 …:
Transport using crane and chains.
 the lifting points are the lifting eyes on the
motor and one drilling in the discharge con-
nection or the suction connection (Fig. 4 - Fig.
6, page 14).
 secure the chains to these lifting points.
 take care that the fittings are not damaged.
Fig. 4: Lifting points, 2BV5 1..
Fig. 5: Lifting points, 2BV5 41./2BV5 421
Fig. 6: Lifting points, 2BV5 47.
5 Installation
 WARNING
Improper handling of the equipment can re-
sult in serious or even fatal injuries!
Have you read the safety notes in chapter 1,
"Safety", page 4 above?
If not then you are not allowed to carry out any
work on or with the equipment!
5.1 Installing the unit
 CAUTION
Danger of crushing if the unit tilts over when
installation is not yet completed!
 Wear gloves and safety shoes!
 Handle the unit cautiously!
 CAUTION
Danger of tripping and falling over the unit!
 avoid the places where tripping may occur!
 WARNING
Electrical hazard!
The system is to be installed in such a way that
external effects cannot lead to damage of the
electrical equipment.
 Lay out the connecting cables safely, e.g. in
cable ducts or in the ground.
 CAUTION
Danger of injury due to parts flying off of a
broken external fan!
 Set the unit up such that if parts of a broken
external fan should fly through the grille, no
personnel can be hit!
CAUTION
Risk of damaging the unit by overheating
due to blocking the path of dissipated heat
and cooling air supply!
 Observe the requirements stated in
"Minimum clearances for heat dissipation",
page 8.
 Make sure that the exhaust air from other
equipment is not drawn in!