Liberty Pumps LowPro-Series - Manual (Page 5)

©Copyright 2012 Liberty Pumps Inc. All rights reserved 5
Pump Specifications LOWPRO41LP
Hp 4/10
Volts 115
Phase 1
Full Load Amps 12
Hz 60
Solids-handling 2"
Discharge size 2"
NOTE: The LowPro has a shut-off head
(maximum lift) of 19 feet. Actual maximum
useable head to provide adequate flow is
approximately 17.5 feet and may be less
depending on amount of run and friction loss
factors. Please consult factory for proper
pump sizing.
Item Part No. Description Qty.
1 4622000 Tank, low profile 1
2 LE41LP Pump, 4/10Hp sewage, 115V 1
3 4623000 Nipple, 2” PVC Sched. 80 1
4 462100B Cover, pump access 1
5 4616000 Switch, vertical master 1
6 462000B Cover, switch access 1
7 8131000 Washer, flat 1/4” X 3/4” S.S. 14
8 8129000 Bolt, 1/4”-20 X 5/8”, Hex head S.S. 14
9 4022000 Stopper, double cord hole 1
10 4624000 Closet Flange, brass 1
11 8018000 Screw, 1/4”-20 X 5/8” slotted Flt. Hd. 4
12 4039000 Gasket, cover 1” X 1/8” tape 1
13 4039RA0 Gasket Tape, for closet flange 1
14 CV200C Check Valve, 2” PVC compression fit 1
15 4762000 Grommet, Pipe seal, 2” 1
16 4627000 Wax Ring 1
17 4626000 Closet flange extension kit 1
18 4625000 Closet bolt kit
1
4. Pump Specifications and Parts List
Refer to the diagram
to adjust the float
switch (5). The
pump should engage
at a waste depth of
approximately 4.0”
and pump down to
around 3.0”. To
adjust the float
switch, remove the
switch access cover
(6) and lift the float
switch (5) out of the
tank. After adjusting
to the lengths
pictured above,
replace the switch by
placing the cord
between the two
bosses. Reattach
the access cover to
the tank.
Fig. 6 Spacer (one each of 1/4" and 1/2" provided.
May be stacked for total of 3/4")
Finish Flooring (Tile, Linoleum etc.)
Sub-flooring (Plywood etc.)