Gorman-Rupp Pumps 810A2-4045T 1529947 and up - Manual (Page 13)

OM-06543 80 SERIES
PAGE B - 6 INSTALLATION
lift station), if a manual shut‐off valve is in­
stalled anywhere in a bypass line, it must
be a full‐opening, ball‐type valve to pre­
vent plugging by solids.
A manual shut‐off valve should not be
installed in any bypass line. A manual
shut‐off valve may inadvertently be left
closed during operation. A pump which
has lost prime may continue to operate
without reaching prime, causing dan­
gerous overheating and possible explo­
sive rupture of the pump casing. Per­
sonnel could be severely injured.
Allow an over‐heated pump to cool
before servicing
. Do not remove
plates, covers, gauges, or fittings from
an over‐heated pump. Liquid within the
pump can reach boiling temperatures,
and vapor pressure within the pump can
cause parts being disengaged to be
ejected with great force. After the pump
cools, drain the liquid from the pump by
removing the casing drain plug. Use
caution when removing the plug to pre­
vent injury to personnel from hot liquid.
AUTOMATIC AIR RELEASE VALVE
When properly installed, a Gorman‐Rupp Auto­
matic Air Release Valve will permit air to escape
through the bypass line and then close automati­
cally when the pump is fully primed and pumping
at full capacity.
Some leakage (1 to 5 gallons [3.8 to 19
liters] per minute) will occur when the
valve is fully closed. Be sure the bypass
line is directed back to the wet well or
tank to prevent hazardous spills.
Consult the manual accompanying the Air Release
Valve for additional information on valve installation
and performance.
Air Release Valve Installation
The Automatic Air Release Valve must be inde­
pendently mounted in a horizontal position be­
tween the pump discharge port
and the inlet side of
the discharge check valve (see Figure 3). The inlet
opening in the Air Release Valve is equipped with
standard 1‐inch NPT pipe threads.