beautypg.com

Gorman-Rupp Pumps 06C1-GAR 1289163 and up User Manual

Page 25

background image

OM--05688

0 SERIES

MAINTENANCE & REPAIR

PAGE E -- 7

SEAL SPRING

SHAFT

KEY

IMPELLER

SHIMS

IMPELLER

RETAINER

O-RING

STATIONARY

SEAT

IMPELLER

SHAFT

PUMP CASING

BELLOWS

ROTATING

ELEMENT

Figure 2. 25271--192 Seal Assembly

This seal is not designed for operation at
temperatures above 160

_

F (71

_

C). Do not

use at higher operating temperatures.

Inspect the pinion shaft (45) for distortion, nicks,
scratches, or damage to the shaft keyway. Dress
small nicks or burrs with a fine file or emery cloth. If
excessive wear exists or the shaft is defective, refer
to

GEARBOX DISASSEMBLY and replace the

shaft.

Lubricate the stationary seat O-ring with light oil
and install it in the groove in the stationary seat.
Use thumb pressure to press this subassembly
into the pump casing until fully seated. Be careful
not to damage the seal face. After installation, wipe
the seal face in a concentric pattern with a clean,
lint-free cloth to remove any fingerprints.

NOTE

It is recommended that a tapered sleeve (see Fig-
ure 3) be installed over the shaft keyway to ease in-
stallation of the rotating portion of the seal. This tool
can be made from steel tubing or black pipe.