ProTeam ProGuard 4 Portable - Manual (Page 9)

ProTeam 9
OPERATION
WARNING - To reduce the risk of fire, explosion, or damage to Vacuum:
• Do not leave Vacuum running while unattended - you may fail to notice important
signs indicating abnormal operation such as loss of suction, debris/liquid exiting
the exhaust, or abnormal motor noises. Immediately stop using Vacuum if you
notice these signs.
• Do not leave Vacuum plugged in when not in use.
• Do not continue running when float has cut off suction.
• Do not operate Vacuum in areas with flammable gases, vapors or explosive dust in
the air. Sparks inside the motor can ignite airborne flammables. Flammable gases
and vapors include: lighter fluid, solvent-type cleaners, oil-based paints,
gasoline, alcohol, and aerosol sprays. Flammable dusts include: coal, magnesium,
aluminum, grain, and gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
• Do not use Vacuum as a sprayer.
WARNING - To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter motor compartment. Store indoors.
• Do not handle plug, switch, or Vacuum with wet hands.
• Do not service Vacuum while it is plugged in. If your Vacuum is not working as it
should, has missing parts, has been dropped, damaged, left outdoors, or dropped
into water, return it to an authorized service center or call customer service.
• When using an extension cord, use only outdoor-rated cords that are in good
condition. Do not allow the connection to come into contact with liquid.
• Do not vacuum toxic materials to reduce the risk of inhaling the vapors or dust.
To reduce the risk of electric shock, this Vacuum has a polarized plug (one blade is
wider than the other). This plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician to install the proper outlet. Do not change the plug in any
way.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position "l".
The symbols used on the switch actuator
are international "On & Off" symbols
(Figure D).
"ON"
"OFF"
Figure D
= = O
OF FF F
= = O
ON N
!
!
SP6768-1 PROTEAM 4 GALLON 12/28/11 11:17 AM Page 9