Infinity Drain S-AS 6548 Series Submittal Sheet - Manual

S-AS 65 Series
S-AS 65│Site Sizeable
- Modify length and locate outlet on-site
- Indoor or outdoor use
- 316 Wedge Wire stainless steel grate
- Stainless Steel channel
- Works with 2″ clamp down floor drain with 2″ throat (strainer size)
(not included)
- Uses Hot Mop, Lead Pan, PVC Vinyl Liner, Rubber Liner (Chloraloy™)
Copper Pan or Fiberglass waterproofing
- Grate can be removed completely for cleaning
- Flow rate 21 GPM per outlet*
*Flow rate measured at outlet only. Measurement does not account
for water in channel or sheeting on shower floor.
Finishes:
_____
Satin Stainless
_____ Polished Stainless
2” clamp down drain not
included in kit
Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for use of superseded or void data.
Infinity Drain
18 Secatoag Avenue
Port Washington, NY 11050
Phone: 516.767.6786
Fax: 516.740.3066
www.InfinityDrain.com
REV. 08.01.2013
Note: Installer must verify all rough-in
dimensions prior to installation and consult
local and national codes. Conformity and
compliance to local and national codes
are the responsibility of the installer.
Page 1 of 2
Complete Kits:
S-AS 6536 36″ Complete Kit
S-AS 6548 48″ Complete Kit
S-AS 6560 60″ Complete Kit
S-AS 6572 72″ Complete Kit
S-AS 6596 96″ Complete Kit
Longer lengths for indoor
or outdoor installations.
Components:
SA 6536 36″ Stainless Steel Grate
SA 6548 48″ Stainless Steel Grate
SA 6560 60″ Stainless Steel Grate
SC 6548 48″ Stainless Open Ended Channel
SC 6596 96″ Stainless Open Ended Channel
LC 6528 28″ Stainless Closed Ended Channel
LC 6540 40″ Stainless Closed Ended Channel
LC 6552 52″ Stainless Closed Ended Channel
LC 6564 64″ Stainless Closed Ended Channel
LC 6588 88″ Stainless Closed Ended Channel
LF 65 8″ Stainless Steel Outlet Section
GJS 65 Stainless Steel Joiner Strip
TNAS
Threaded Nipple
Sikaflex 1a Construction Sealant
Add Clamp Down Drain:
CDA 22 Clamp Down Drain ABS
CDI 22 Clamp Down Drain Cast Iron
CDP 22 Clamp Down Drain PVC
Optional Components:
SLA 65 Stainless Steel 90° Angle Joiner
TNRN
Stainless Steel Threaded Nipple (3"
extension)
UCP 2 Universal 2” Clamping Plate
UCP 4 Universal 4” Clamping Plate
ERB Eccentric Reducer Bushing 4”x2”
Installation (S) Site Sizable
SE 65 Stainless Steel End Section