Infinity Drain FFDG 6536 Series Submittal Sheet - Manual

FFDG 65 Series
FFDG 65│Fixed Length
- 16 gauge 304 Stainless Steel grate and channel
- Pre-pitched channel with “Fixed” lengths and “Fixed” center vertical
(down) outlet location
- Not site sizeable
- Indoor or outdoor use
- Bonded “Flange” installation for flush against the wall.
- Lowest height for curbless installations
- Uses Liquid and Fabric Sheet Membrane waterproofing
- Grate can be removed completely for cleaning
- Flow rate 9 GPM per outlet*
*Flow rate measured at outlet only. Measurement does not account
for water in channel or sheeting on shower floor.
Finishes:
_____
Satin Stainless
_____ Polished Stainless
Complete Kits:
FFDG 6532 32″ Complete Kit
FFDG 6536 36″ Complete Kit
FFDG 6542 42″ Complete Kit
FFDG 6548 48″ Complete Kit
FFDG 6560 60″ Complete Kit
Components:
DA 6532 32″ Stainless Steel Grate
DA 6536 36″ Stainless Steel Grate
DA 6542 42″ Stainless Steel Grate
DA 6548 48″ Stainless Steel Grate
DA 6560 60″ Stainless Steel Grate
FC 6532 32″ Stainless Steel Fixed Channel
FC 6536 36″ Stainless Steel Fixed Channel
FC 6542 42″ Stainless Steel Fixed Channel
FC 6548 48″ Stainless Steel Fixed Channel
FC 6560 60″ Stainless Steel Fixed Channel
Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for use of superseded or void data.
Infinity Drain
18 Secatoag Avenue
Port Washington, NY 11050
Phone: 516.767.6786
Fax: 516.740.3066
www.InfinityDrain.com
REV. 08.01.2013
Note: Installer must verify all rough-in
dimensions prior to installation and consult
local and national codes. Conformity and
compliance to local and national codes
are the responsibility of the installer.
Page 1 of 2
Installation (FF) Fixed Flange