Imetec BELLISSIMA FLASH & GO DISPOSABLE LAMP User Manual
Page 86
GB
80
the skin colour: if the skin colour is fair enough for a safe application, the
appliance emits the light pulse on the skin together with a sound and
the ready-for-use leDs (6) go off. a slight tingling sensation may be felt.
Note: if the appliance does not emit a light pulse and the skin colour check
leDs (6a) flash, the skin tone is too dark for a safe application. try to use
the appliance on another part of the body.
10. remove the treatment surface (5a) from the treated area.
11. 3.5 seconds after the previous pulse is emitted, the ready-for-use leDs
(6) light up again.
12. Move the treatment surface (5a) to another section. use the pressure
marks left previously to place the treatment surface on the adjacent section,
avoiding overlapped pulses (see “Covering the entire treatment area”).
13. repeat the process, starting from point 8, until the entire area to be
treated is covered.
aFtEr trEatMENt
14. press the switch-on/stand-by button (10): all the leDs that are on, go off
and the stand-by leD lights up (9).
15. remember the power level used for the treatment session as this will be
reset when the appliance is next switched on.
16. Disconnect the adapter cable (14) from the socket.
caring for the skin after the hair removal session.
see “other precautions for safe use”.
MI000875.indd 80
02/04/12 13.14