Extron Electronics SW4 3G HD-SDI User Guide - Manual (Page 12)

SW4 3G HD-SDI • Introduction
Introduction
1-2
About this Manual
The Extron SW4 3G HD-SDI switcher is a four-input, two
parallel output, multi-rate switcher. It allows up to four SDI
or HD-SDI video input sources to be switched to two identical
outputs on female BNC connectors.
The SW4 HD-SDI supports multiple SDI rates, including
270 Mbits per second, 1.485 Gbps, and 2.97 Gbps.
The switcher can be controlled via the front panel buttons, or via
RS-232 communication, using Extron’s Simple Instruction Set
(SIS ™ ).
It also features an auto-input switch mode that automatically
switches to the highest numbered input with active sync pulses
present. Executive mode is available to lock out the front panel
as a security measure.
Features
• Switches video signals of all common serial digital data
rates up to 3G-SDI.
• Inputs: four inputs on female BNC connectors for SDI,
HD-SDI, or 3G-SDI digital component video
• Input equalization: each input is equalized, regardless of
its rate.
• Outputs: two parallel outputs on female BNC connectors
for simultaneous monitor and projector viewing
• Output re-clocking: when the input rate is recognized
as 270 Mbps, 1.485 Gpbs, or 2.97 Gbps, the output is
re-clocked to the recognized rate.
• An RS-232 port for serial communication and control
• Retention of unit settings after power loss
• Flash upgradeable firmware
• Auto-input switching capability
• 1U, half rack width metal enclosure
• Internal 100-240 V, 50/60 Hz power supply