Extron Electronics VGA Termination Kit - Manual

68-516-01 Rev. B
08 08
VGA Termination Kit Instructions
1 . On the back of the connector, solder jumper wires from pin 6 to pin 7, from
pin 7 to pin 8, from pin 8 to pin 10, and from pin 10 to the shell (see the pinout
table on the back of this card).
2 . Strip away approximately 1" of the outer jacket of the 5-wire coaxial cable.
3 . Trim the outer foil shield back to a length of approximately 0.25".
4 . For each coax cable:
a . Carefully strip away approximately 0.5" of
the jacket from the end of the coaxial cable
to expose the spiral shield.
b . Twist the spiral shield together and bend
the twist aside.
c . Carefully strip away approximately 0.25" of
the insulation to expose the center conductor.
Outer
Jacket
Insulation
Center
Conductor
1"
1/2" 1/4" 1/4"
Foil Shield
Spiral Shield
Outer Foil Shield
Pinout
Pin Coax
1 Red conductor
6 Red shield
2 Green conductor
7 Green shield
3 Blue conductor
8 Blue shield
Pin Coax
13 Black conductor
10 Black shield
14 Yellow conductor
10 Yellow shield 5
1
15
11
6
10
Jumper
d . Solder the center conductor of the cable to the pin’s
solder cup shown in the table below.
5 . Twist all of the conductors’ spiral shields (from 4b) together
and solder them to pin 10 or to the connector shell.
6 . Fasten the two halves of the backshell together around
the front plate of the connector using the provided
screws and nuts.
Twist all 5 shields
together and solder.
Center
Conductor
Solder Cups
Coax
Cables
Backshell
Jumper
Front Plate