beautypg.com

Extron Electronics XTP DTP 24 Plug Kit for XTP DTP 24 Cable User Manual

Page 2

background image

68-1813-01

Rev.

E

04 13

Extron USA Headquarters
+1.800.633.9876 (Inside USA/Canada Only)

Extron USA - West:

+1.714.491.1500

FAX: +1.714.491.1517

Extron USA - East:

+1.919.850.1000

FAX: +1.919.850.1001

© 2013 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners.

www.extron.com

7.

Feed the individual wires, in the correct order,
through the open front face of the plastic
guide and out through the individual holes at
the other side. The rear of the guide should
be seated against the end of the jacket and
braid.

8.

Cut the wires to 0.6 inch (15.2 mm) as shown
at right.

9.

Push the guide up, leaving 0.3 inch of the
wires exposed above the guide (see image
at right).

10.

Insert the guide and wires into the RJ-45
connector, making sure the wires pass the
crimping teeth of the connector.

NOTE: Ensure the wires are in the correct

order (see table on the previous page)
and the bottom of the connector is
next to the braid shield that was folded
under the cable in step 4.

11.

Insert the connector into the termination tool
and crimp it to secure the connector to the
cable. Use pliers to secure the connector
tabs around the cable and the ground.

NOTE: To ensure correct grounding

throughout the cable, the braid shield
(folded back in step 4) must make
contact with the shielded RJ-45
connector on both ends of the cable.

12.

If a strain relief is present, slide it forward to
cover the cable and the first 0.4 inch
(10.2 mm) of the RJ-45 connector.

13.

Test both ends of the cable for conductivity.

NOTE: If there is a need to re-terminate the

cable, cut off the terminated end of the
cable and repeat steps 2 through 12.

7

Guide

Heat Shrink Tubing/
Strain Relief (optional)

8 0.6"

11

Ensure conductors are seated

properly under contacts.

Front

NOTE:

10

9

0.3"