Extron Electronics USFM 100 Installation - Manual

1
The Extron USFM 100 is a mounting kit for suspending ultra short throw projectors from a wall. The USFM 100 base
plate enclosure is capable of mounting a PoleVault
® System switcher and its supplied power supply, with sufficient
room remaining for installing additional devices and cable management. It is designed to be used with the UPB 25
universal projector bracket (supplied with the Extron WallVault
® system).
The USFM 100 has knockouts on all four sides that allow external raceways or conduits to be attached for cabling
runs where necessary.
CAUTION: Maximum projector load for the USFM 100 boom arm is 20 lbs (9.1 kg).
Extron
USFM 100
Plastic Enclosure Cover
Boom Arm
Base Plate
Arm Cover (buttom)
Arm Cover (top)
Arm Cover (front)
Device Mounting Plate
Figure 1. USFM 100 Parts
Hardware Included in the Kit
Parts Qty Application
¼ - 20 x 2 inch, pan head bolts, 4 Base plate to wall installation
¼ inch Toggle assembly 4 Base plate to wall installation
¼ inch metal washers (47/64 inch OD) 8 Base plate to wall installation
5/16 x 3 inch lag screws 4 Base plate to wall installation
5/16 inch metal washers (11/32 inch ID, 11/16 inch OD) 4 Base plate to wall installation and boom arm
¼-28 x 3/4 inch hex screw 1 Securing boom arm (top)
¼-20 x 1/2 inch button hex screws 4 Securing boom arm (extension)
10-32 x 3/8 inch pan head screws 2 Securing boom arm (bottom)
10-32 x ¼ inch set screw, 1 Securing projector pipe
6-32 x ¼ inch button hex screws 11 Securing covers for boom arm (10)
Securing device mounting plate (1)
6-32 x ½ inch button hex screws 4 Securing plastic covers for enclosure
Tie wraps 4 Securing power supply wires
4-40 x ¼ inch pan head screws 2 Securing switcher to plate
USFM 100 Installation Guide