beautypg.com

Extron Electronics USB PowerPlate 200 Series Installation User Manual

Usb powerplate 200 series installation guide, Connectors, Installation

background image

68-2373-01

Rev.

A

03 13

USB PowerPlate 200 Series Installation Guide

The Extron

®

USB PowerPlate 200 Series are USB power

charging products that provide power for electronic mobile
devices (such as smartphones and tablets) from an external
Extron power supply.
Each PowerPlate model has two USB Type A female
connectors.
The PowerPlate 200 AC AAP adds a pass-through AC
receptacle.

Connectors

Power (12 V) — The included external power supply connects
to the 2-pole connector to provide power for the USB
connectors.
USB Output — The two USB connectors can supply up to 2.1 A
(shared between the connectors) at 5 volts (10.5 watts).
AC Pass Through (AC AAP only) — The AC pass-through is
rated for up to 12 amps.

NOTE:

USB PowerPlate 200 series products distribute power

between the two USB connectors according to the requirements
of each connected device. Large tablets and other devices can
have high power requirements. When the maximum available
power is reached, the connected device may notify that it is not
charging while receiving a low charge.

Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)

Extron Asia
+65.6383.4400

Extron China
+86.21.3760.1568)

Extron Korea
+82.2.3444.1571

Extron Europe
+31.33.453.4040

Extron Japan
+81.3.3511.7655

Extron Middle East
+971.4.299.1800

Extron India
+91.80.3055.3777

© 2013 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners.

www.extron.com

NOTES:

This unit must be installed in accordance with the National
Electrical Code and with all local codes.

Ensure that the installation meets the local and state regulatory
requirements, including building, electrical, and safety codes,
and UL and ADA accessibility requirements.

Installation

Power (12 V) — You must connect the included external power
supply to the 2-pole connector. Run the power supply wires to
the rear of the USB circuit board.
Connect the power supply wires as shown.

SECTION A–A

A

A

Power Supply

Output Cord

Ridges

Smooth

3/16"

(5 mm) Max.