Cutting the opening, Caution, 2wear safety glasses 2 – Extron Electronics Routing Template User Guide User Manual
Page 2
68-625-01 Rev. G
11 13
Extron Headquarters
+800.633.9876 Inside USA/Canada Only
Extron USA - West
Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX
+1.919.850.1001 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
Extron India
1800.3070.3777
(Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
©
2013 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
www.extron.com
Cutting the Opening
Follow the steps below to cut the hole in the table.
CAUTION:
The opening in the table should be cut only by licensed and bonded craftspeople. Exercise care to prevent
personal injury or damage to the furniture. Extron is not responsible for miscut mounting holes.
1/2" Router Bit
5/8" Guide Bushing
1
1.
Install a 5/8-inch (16 mm) outside diameter guide bushing
and a 1/2-inch (either 12 mm or 12.7 mm) diameter
straight router bit on a standard router (
a
).
3.
Remove the C-clamps, lumber, cloth, and the routing
template.
NOTE:
The routing template is reusable. Do not
discard this template when installation is complete.
Save it for installing future surface access
enclosures of the same size.
HS
A 200
US
ER
ACCE
SS
HS
A 200
CA
BLE
CUB
BY 30
0
CA
BLE
CUB
BY 3
00
US
ER A
CC
ESS
Router
2
Wear Safety Glasses
2.
Carefully cut the opening in the table surface with the
router (
b
)
CAUTION:
Wear safety glasses when operating the
router. Failure to comply may result in eye injury.