Extron Electronics SMA-1 User Guide User Manual
Sma-1 swivel mount adapter kit • user guide, Overview, Sma-1 parts
Overview
The Extron
®
SMA-1 swivel mount adapter kit is used with an SMB 303 box for tabletop installation of Extron devices. The
assembly can be rotated up to approximately 180° in either direction from a starting reference point. The angle can be set
by the user.
SMA-1 Parts
The five component parts of the SMA-1 (see the figure to the right) are
preassembled for shipping:
z
Locking nut
z
Backing plate
z
Swivel disk
z
Insulation disk
z
Conduit (with base)
In addition, the kit includes:
z
Mounting screws
z
Set screws
z
Hex key
z
Snakeskin wire cover
Getting Started
Choose a location for mounting the SMA-1. The installation site must be free of obstructions above and below the table. If
the SMB 303 box is mounted with the SMA-1, the box must also be able to rotate as desired.
Securing the Base of the SMA-1 to the Table
1.
Use the cut-out template (provided) to mark the position of the SMA-1.
2.
Drill a hole through the table that is 1 inch (2.54 cm) in diameter to accommodate cables.
3.
On the cut-out template, mark the stopping points and the reference point.
NOTES: The reference point indicates the direction in which the mounted device faces at rest. The stopping points
must be correctly aligned with the reference point to limit the clockwise and counterclockwise rotation of
the assembly, as desired.
Only two stopping points can be used in any setup. If additional set screws are added, only the two screws
closest to the reference point (one clockwise and one counterclockwise) will function as stopping points.
Rotate the template until a suitable combination of stopping points aligns with the reference point.
There are many possible combinations of stopping points. Figure 1 (below) shows three of the most common
setups.
One stopping point allows
assembly to rotate 180°
in either direction.
Reference Point
Two stopping points allow
assembly to rotate approximately
90° in either direction.
Reference Point
Two stopping points allow
assembly to rotate 90° counter
clockwise and 180° clockwise.
Reference Point
Figure 1.
Setting Reference Points
1
SMA-1 Swivel Mount Adapter Kit • User Guide
Locking Nut
Backing Plate
Swivel Disk
with Felt Cover
Insulation Disk
Conduit
Mounting Hole
Stopping Point