beautypg.com

Cable the smb 303, Cable wrap connect and mount the devices, Cabling from the rear – Extron Electronics SMB 303 User Manual

Page 2: Cabling from underneath

background image

SMB 303 Surface Mount Box • Installation Guide (Continued)

68-1944-01

Rev. A
10 10

Extron USA - West
Headquarters

+800.633.9876

Inside USA/Canada Only

+1.714.491.1500
+1.714.491.1517
FAX

Extron USA - East

+800.633.9876

Inside USA/Canada Only

+1.919.863.1794
+1.919.863.1797
FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040
+31.33.453.4050
FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400
+65.6383.4664
FAX

Extron Japan

+81.3.3511.7655
+81.3.3511.7656
FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568
+86.21.3760.1566
FAX

Extron Middle East

+971.4.2991800
+971.4.2991880
FAX

©

2010 Extron Electronics All rights reserved.

www.extron.com

Cabling from the Rear

1.

Bundle the wiring using the provided cable wrap
and feed it through the rear cable access opening.

2.

Trim the strain relief boot to fit the bundle of
wiring and cable wrap diameter.

3.

Slide the strain relief boot over the wire and cable
wrap and into the cable access opening.

4.

Place the strain relief clamp into the boot and
fasten with the provided screws.

5.

Secure the wires and cable wrap with a zip tie (see
below).

Cable the SMB 303

Cabling must be done prior to mounting devices on the SMB 303.

NOTE: Some wiring slack is required for installation and

removal of devices.

Zip Tie

Cable Wrap

Connect and Mount the Devices

Once cabling is secure, connect the devices and mount them to the SMB 303 according to the mounting instructions
included with each device.

Cabling from Underneath

1.

Install the rear cable access cover into the rear cable
access opening using the provided screws.

2.

Bundle the wiring using the provided cable wrap and
feed it from under the furniture through the bottom
cable access hole.

3.

Secure the cable with one or more zip ties (see inset at
right).

a

Rear Cable

Access Cover

c

Zip Tie

b

Cable Wrap

a Cable Wrap

Strain Relief Boot
b Cut to proper size.
c Slide over wiring

and cable wrap.

d Strain Relief

Clamp

Rear Cable

Access Opening