beautypg.com

Extron Electronics PVT CV EU Installation User Manual

Pvt rgb eu and pvt cv eu installation guide, Vid eo in ir o ut s g au dio in l r, Step 5 step 6

background image

4.

Carefully cut off the terminating RJ-45 connector from each cable.

5.

Strip the insulator of each cable wire back approximately 0.43" (1.1 cm).

6.

Following the wiring diagram and table below, use a Tweeker to press down the spring switch,

and insert each wire into its correct location in the connector on the rear of the applicable PVT.

Release the spring to hold the wire securely in place.

7.

Euro Channel — Place the plastic cover into the grooves of the Euro Channel, over the adapter

plate(s), and firmly insert the PVT wall plate, pushing any spare wire into the raceway.

Junction boxes — Align and snap the PVT wall plate into the adapter plate, clamping the plastic

cover into position.

8

. Connect the applicable input device to the PVT.

9

. Power on the input device and the Polevault switcher.

N The PVT wall plate is powered by the PoleVault switcher.

1.

Run the A/V input cables from the PoleVault switcher along the Euro Channel or behind the wall

to the desired junction box location.

N

Two cables (A and B) are needed for one PVT RGB EU.

2.

Either:
• Place the supplied mounting adapter plate(s) behind the grooves at the front of the

Euro Channel, or

Using the supplied screws, attach the adapter plate directly to the junction box.

N

The orientation of the adapter plate, vertical or horizontal, determines the orientation of the PVT’s.
For a 2-gang mounting bracket or junction box, use two adapter plates. Ensure that they touch
but do not overlap.

3.

Thread the cables through the adapter plate and the supplied plastic cover.

Euro Channel
(not included)

Extron
PVT CV EU

Composite Line Driver

VID

EO

IN

IR O

UT

S

G

AU

DIO

IN

L

R

Junction Box
(not included) Metal

Supporting
Frame

PVT RGB EU and PVT CV EU Installation Guide

Extron Electronics, USA
800.633.9876 714.491.1500
FAX 714.491.1517

Extron Electronics, Europe
+800.3987.6673 +31.33.453.4040
FAX +31.33.453.4050

Extron Electronics, Asia
+800.7339.8766 +65.6383.4400
FAX +65.6383.4664

Extron Electronics, Japan
+81.3.3511.7655
FAX +81.3.3511.7656

www.extron.com

68-1507-01

Rev A

03 08

Extron
PVT CV EU

Composite Line Driver

VID

EO

IN

IR

OU

T

S

G

AU

DIO

IN

L

R

Junction Box
(not included)

Metal
Supporting
Frame

The PVT RGB EU and PVT CV EU 1-gang A/V wall plates for PoleVault

Systems can be installed in

80 mm Euro Channel raceways or European junction boxes.
To install either of the devices:,

Strip the insulator
0.43" (1.1 cm).

Press to hold the spring open.
Insert the wires according to
the table.
Release to close the spring.

Step 5

Step 6

1

2

3

4

5

6

7

8

5

Pin

1

Red +

2

Red –

3

H. sync +

Green –

6

H. sync –

7

Blue +

8

Blue –

4

Wire Color

White-green
Green
White-orange

White-blue

Orange
White-brown
Brown

568A

Cable B

Green +

Blue

Cable A

V. sync +

V. sync –

+ 5 VDC

Audio L –

GND
Audio R +

Audio R –

Audio L +

Composite
Video Signals

Video +

Video –

+ 5 VDC

Audio L –
GND
Audio R +
Audio R –

Audio L +

RGB Signals

Top of

device

1

1&2

3&6 4&5 7&8

2345678

Cut off the
RJ-45 connector.

Twisted
Pairs

Step 4

Wire Color

568B

White-green

Green

White-orange

White-blue

Orange

White-brown
Brown

Blue

Cut below

PVT RGB EU and PVT CV EU Installation Guide, cont’d

This manual is related to the following products: