Extron Electronics PVT SW HDMI RGB D Setup Guide - Manual (Page 2)

PVT SW HDMI RGB D • Installation Guide (Continued)
Extron USA Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.8 50.1000
+1.714.491.1517 FAX +1.919.8 50.1001 FAX
Extron Europe
+800.3987.6673 (Inside Europe Only)
+31.33.453.4040
+31.33.453.4050 FAX Extron India
1800.3070.3777 (Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
© 2013 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners.
www.extron.com
68-2381-01
Rev A
10 13
5. For audio pass through, run the audio output cable from the PoleVault
switcher to the PVT location and connect to the rear 3-pole AUDIO IN
captive screw connector, observing L = left, R = right, = ground (see
image at right).
6. Mount the cabled device into the mud ring or wall box and attach the
supplied Decora
® faceplate.
7. Connect a HDMI source to the front panel HDMI input connector.
8. Connect an RGB high resolution source device to “VGA In” and a local
display device to “Local Out”.
9. Connect audio sources to the audio input tip-ring-sleeve jack.
10. Connect a recording device or an assistive listening system to the audio output jack.
11. Connect the IR emitter to the front panel 2-pole captive screw connector with the signal
wire in the hole marked “S” and the ground wire in the hole marked “G.”
Place the IR emitter near or in front of the IR pickup sensor on the source device.
NOTE: To complete system installation, see the Digital PoleVault System Installation Guide
(featuring the PVS 405D switcher), available online at www.extron.com.
Sleeve (Gnd)
Ring (R)
Tip (L)
3.5 mm Stereo Plug
(unbalanced)
L R
L
R
Left
Right
Ground