Extron Electronics RGB 203 Rxi Setup Guide - Manual (Page 4)

RGB 203 Rxi • Setup Guide (Continued)
68-655-51
Rev A
11 10
Extron USA - West
Headquarters
+800.633.9876
Inside USA/Canada
Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA/Canada
Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
© 2010 Extron Electronics. All rights reserved. www.extron.com
Local Monitor Pass-through EDID
To use local monitor pass-through EDID:
1. If you have not already done so, connect the RGB 203 Rxi to the source device. Do not switch on the source device at
this time.
2. Set the rotary switch to position F.
3. If you have not already done so, connect a monitor to the Local Monitor output and power on that monitor and
interface.
4. Power on the remote display device.
5. Power on source device.
Operation
Level/boost ( i ) — Use this knob to alter picture brightness.
Peak ( j ) — Use this knob to alter picture sharpness.
Centering controls — Use these knobs to center the image on the screen vertically ( { k ) or horizontally ( [ l ).
LCD display ( p ) — When the centering controls are being used, this display shows centering information. At other times it
shows scan rate.
Input selection (
q ) — This three-way switch selects among inputs. The corresponding LED ( r ) lights.
Troubleshooting
No response to { or [ centering controls:
• DDSP is in use. Set DIP switch 1 on the rear panel to Off.
• Front panel security lockout disables centering. Disable front panel security lockout (see RGB 203 Rxi User Guide).
No response to switching controls:
• Front panel security lockout disables switching. Disable front panel security lockout (see RGB 203 Rxi User Guide).
If the image does not appear or is incorrectly displayed:
• Ensure that all devices are plugged in and receiving power. The front panel LCD of the interface lights if the interface is
receiving power and an active sync signal. Check the cabling and the audio connector wiring and grounding, and make
adjustments as needed.
• If using the model that has the EDID Minder, make sure the rotary dial and frequency DIP switch are set to the correct
values. If these settings are changed, reboot the source device.
• If using the model that has the EDID Minder, make sure the video output device can support the resolution provided by
the EDID Minder. If necessary reset the rotary dial and reboot the source device.
NOTE: See the RGB 203 Rxi User Guide for a complete troubleshooting guide.