beautypg.com

Extron Electronics P-2 DA2 WM F, WM F AAP, EC F, D Setup Guide User Manual

Setup guide — p/2 da2 wm f, wm f aap, ec f, d, Installation, Step 1 — power down

background image

Setup Guide — P/2 DA2 WM F, WM F AAP, EC F, D

This guide provides basic instructions for an experienced

installer to set up and operate the Extron

®

P/2 DA2 WM F, WM F AAP, EC F, D Series of

distribution amplifiers.

Installation

These distribution amplifiers are high performance one input, two output video devices with

audio that accept video input from a VGA-QXGA compatible PC and distributes that signal to

separately buffered outputs. Refer to the user manual for specific mounting instructions. An

example application for the P/2 DA2 D is shown below. Refer to the user manual for other

application and installation examples.

CO

MP

UT

ER

IN

MO

NIT

OR

OU

T

AU

DIO

IN

Projector

Extron
MHR-5 Cable

PC w/ Audio

Extron
P/2 DA2 D

Distribution Amplifier

Audio

Audio
Output

Extron
MPA 122

Mini Power Amplifier

PO

WE

R

12V
3A

MA

X.

OU

TPU

TS

4/8

Ohm

s SP

EAK

ERS

INP

UT

S

L

R

L

R

RE

MO

TE

10V
VO

L/M

UT

E

L

MP

A 1

22

R

C

US

Extron
SI 3CT LP

Full-Range Ceiling
Speakers

C

Installation and service must be performed by authorized personnel only.

Step 1 — Power down

Power off the display device, the PC and its local monitor.

Step 2 — Connect inputs

For video input, connect the VGA output of the PC to the Input or Computer In 15-pin

HD connector on the faceplate of the distribution amplifier.

For unbalanced stereo audio input, connect the input device

to the 3.5 mm female audio jack on the faceplate of the

distribution amplifier. Wire the audio plug as shown on the

right.

Step 3 — Connect outputs

If a local monitor is being used, connect the monitor of the PC to the Buffered Local

Monitor or Monitor Out 15-pin HD output connector on the faceplate of the distribution

amplifier.

(Continued on reverse side)

Sleeve ( )

Ring (R)

Tip (L)