Setup guide — p/2 da2xi, Operation, Step 5 — power up – Extron Electronics P-2 DA2xi Setup Guide User Manual
Page 2
Setup Guide — P/2 DA2xi
68-1239-50
Rev. A
01 10
Step 5 — Power up
Connect the power supply cord of the P/2 DA2 Plus to a 100 to 240 VAC power source and
power up the local monitor, PC, and display device.
C
Always use a power supply specified by Extron for the
P/2 DA2xi. Use of an unauthorized power supply voids all
regulatory compliance certification and may cause damage to the
power supply and the P/2 DA2xi.
Power Supply
Output Cord
Captive Screw
Connector
3
5
SECTION A–A
Ridges
Smooth
A
A
Tie Wrap
C
Power supply voltage polarity is critical. Incorrect voltage polarity can
damage the power supply and the P/2 DA2xi. Identify the power cord
negative lead by the ridges on the side of the cord.
Operation
After the P/2 DA2xi and its connected devices are powered up, the system is fully operational.
If any problems are encountered, verify that the cables are routed and connected properly.