Extron Electronics MTP DA8 User Guide - Manual (Page 15)

Side
RJ-45
Connector
12345678
Insert
Twisted
Pair Wires
Pins:
NOTE: When the TP input is from a low resolution unit (MTP SV or MTP AV),
the signal assignment depends on the position of signal jumpers in
the transmitter and receiver (see the MTP AV Series User Guide).
Jumpers in Mono Position (Default)
Pin 568 A Wire
Color
568 B Wire
Color
Composite Video
MTP Signal
S-video
MTP Signal
RGB Video, MTP,
VTT/VTR Signal
1 White-
green
White-
orange
Reserved Chroma (C) + Red/
V.Sync +
2 Green Orange Reserved Chroma (C) – Red/
V.Sync –
3 White-
orange
White-
green
Mono audio + Mono audio + Mono audio + or
RS-232 +
(MTP 15HD only)
4 Blue Blue Video + Luma (Y) +
5 White-blue White-blue Video – Luma (Y) – Green –
6 Orange Green Mono audio - Mono audio – Mono audio – or
RS-232 –
(MTP 15HD only)
7 White-
brown
White-
brown
Reserved Reserved Blue/
H.Sync +
8 Brown Brown Reserved Reserved Blue/
H.Sync –
Jumpers in Stereo Position
Pin 568 A Wire
Color
568 B Wire
Color
Composite Video
MTP Signal
S-video
MTP Signal
1 White-
green
White-
orange
Video + Luma (Y) +
2 Green Orange Video – Luma (Y) –
3 White-
orange
White-
green
Reserved Reserved
4 Blue Blue Audio left + Chroma (C) &
audio left +
5 White-blue White-blue Audio left – Chroma (C) &
audio left –
6 Orange Green Reserved Reserved
7 White-
brown
White-
brown
Audio right + Audio right +
8 Brown Brown Audio right – Audio right –
NOTE: If you are using Enhanced Skew-Free™ AV cable, use the
TIA/EIA T 568A standard only.
Figure 6. TP Cable Termination
MTP DA4 and MTP DA8 • Installation and Operation 9