Power supply wiring, Ew connector (see – Extron Electronics MTP DA8 User Guide User Manual
Page 13
NOTES:
•
The MTP DA output does not provide any pre-peaking control. The total
recommended distance for a complex system with multiple DA outputs is
the same as for a simple system with a single transmitter and receiver.
•
See the recommended transmission ranges in the table on page 2. The
recommendations in the table apply to a complete transmission system,
which can include a single transmitter, DA, and multiple receivers or a
complex system including multiple daisy-chained receivers.
d
Output Mute connections — The Output Mute connector provides a way to mute
(blank) any or all TP outputs. Each numbered pin of the captive screw connector is
assigned to one of the DA outputs. Pin A is assigned to all DA outputs (see
4).
When you short and latch a numbered pin or pins to ground, the DA mutes the
associated outputs.
1 2 3 4 5 6 7 8 A
MTP DA8
Output Mute Connector
1 2 3 4 A
MTP DA4
Output Mute Connector
Pin
Contact
Closure
Function
1
Out #1
Mute output #1
2
Out #2
Mute output #2
3
Out #3
Mute output #3
4
Out #4
Mute output #4
5
Out #5
Mute output #5
6
Out #6
Mute output #6
7
Out #7
Mute output #7
8
Out #8
Mute output #8
A
Out All
Mute all outputs
Gnd
Ground
Figure 4.
Mute Connector and Pinout
Power Supply Wiring
5 shows how to wire the power connector (see the caution, attention, and notes on
the next page before wiring the power connector).
SECTION A–A
A
A
Power Supply
Output
Cord
2-Pole Captive Screw
Connector
Ridges
Smooth
Tie Wrap
3/16”
(5 mm) Max.
Figure 5.
Power Connector Wiring
MTP DA4 and MTP DA8 • Installation and Operation
7