Extron Electronics MBU 149 User Manual
Setup guide — mbu 149, Setup guide — mbu 149, cont’d, Installation
Setup Guide — MBU 149
Setup Guide — MBU 149
Setup Guide — MBU 149, cont’d
Setup Guide — MBU 149, cont’d
(Continued on reverse side)
(Continued on reverse side)
The Extron
®
MBU 149 Under-Desk Mount Kit (part number
70-222-01) lets you attach an Extron 1U high device to the
underside of a desk or table, or to a wall. The brackets
extend approximately ¼" (6 mm) above the top surface of the
device, which allows an air space between the enclosure and
the mounting surface.
Installation
Step 1 — Attach brackets to device
Attach brackets to the device with the supplied machine
screws, as shown on the left side of the picture below.
Step 2 — Mark screw location
Hold the device with attached brackets against the
wall or the underside of the furniture, and
mark the screw hole locations (centers of
the brackets’ screw slots).
Step 3 — Drill holes
Drill four pilot
holes, each
3/32" (2 mm)
in diameter, ¼"
(6 mm) deep,
at the locations
marked in step 2.
#8 Screw
(4 Places)
Each Side
Mounting Screws
(2 Places)
Each Side
Mounting
Bracket
The Extron
®
MBU 149 Under-Desk Mount Kit (part number
70-222-01) lets you attach an Extron 1U high device to the
underside of a desk or table, or to a wall. The brackets
extend approximately ¼" (6 mm) above the top surface of the
device, which allows an air space between the enclosure and
the mounting surface.
Installation
Step 1 — Attach brackets to device
Attach brackets to the device with the supplied machine
screws, as shown on the left side of the picture below.
Step 2 — Mark screw location
Hold the device with attached brackets against the
wall or the underside of the furniture, and
mark the screw hole locations (centers of
the brackets’ screw slots).
Step 3 — Drill holes
Drill four pilot
holes, each
3/32" (2 mm)
in diameter, ¼"
(6 mm) deep,
at the locations
marked in step 2.
#8 Screw
(4 Places)
Each Side
Mounting Screws
(2 Places)
Each Side
Mounting
Bracket
68-704-01
Rev. B
09 09
68-704-01
Rev. B
09 09
Step 4 — Install screws
Insert the wood screws (provided) into the pilot holes. Fasten each screw into the furniture or
wall until the screw heads protrude slightly less than ¼" (6 mm) from the mounting surface.
Step 5 — Align brackets with screws
Align the screws with the slots in the mounting brackets and place the device against the
surface, with the screw heads through the bracket slots.
Step 6 — Adjust and fasten
Slide the device slightly forward or back, then tighten all screws to fasten it to the furniture or
wall, as shown on the right side of the diagram on the front of this guide.
Step 4 — Install screws
Insert the wood screws (provided) into the pilot holes. Fasten each screw into the furniture or
wall until the screw heads protrude slightly less than ¼" (6 mm) from the mounting surface.
Step 5 — Align brackets with screws
Align the screws with the slots in the mounting brackets and place the device against the
surface, with the screw heads through the bracket slots.
Step 6 — Adjust and fasten
Slide the device slightly forward or back, then tighten all screws to fasten it to the furniture or
wall, as shown on the right side of the diagram on the front of this guide.