Extron Electronics MSW 4V rs User Guide - Manual (Page 14)

Mode Selection
The default method for changing channels is Normal mode (using front panel buttons). To
activate auto switch mode:
1. Press and hold the Mode (Input 1) and Auto (Input 3) buttons simultaneously.
2. Release the Mode and Auto buttons simultaneously. The Auto Switch LED turns on,
indicating that auto switch is enabled.
A/V SWITCHER
MODE NORMAL AUTO
AUTO
SWITCH 1 2 3 4
Figure 7. Turning on Auto Switch Mode
To turn auto switch mode off (Normal mode):
1. Press and hold the Mode (Input 1) and Normal (Input 2) buttons simultaneously.
2. Release the Mode and Normal buttons simultaneously. The Auto Switch LED is unlit
and the MSW switches to the previously selected input
A/V SWITCHER
MODE NORMAL AUTO
AUTO
SWITCH 1 2 3 4
Figure 8. Turning off Auto Switch Mode
Output (Video) Mute
Video mute suppresses video signals being sent to either output.
1. Press and hold the Mode (Input 1) and Input 4 buttons simultaneously.
2. Release both buttons simultaneously. The output (video) signal is muted.
To restore the video signal, press the same buttons:
1. Press and hold the Mode (Input 1) and Input 4 buttons simultaneously.
2. Release both buttons simultaneously. The output (video) signal is restored.
Vertical Interval Switching
The MSWs switch inputs during the vertical interval of the video signal that is on input 1.
In a genlocked system, switching to any input is glitch-free if one of the genlocked devices
is connected to input 1.
MSW 4V rs and MSW 4SV rs • Panel Features 8