Receiver rear panel features, Eceiver outputs (see, Eb c d a – Extron Electronics MTP 15HD RS Series User Guide Rev. C User Manual
Page 17
Receiver Rear Panel Features
See figure 6 and the following descriptions to identify the rear panel features on the
MTP RL 15HD RS receiver.
INPUT
BUFFERED
OUTPUT
OUTPUT
POWER
12V
0.5A MAX
MTP RL 15HD RS
RS-232
Rx
Tx
OUTPUTS
G
E
B C
D
A
Figure 6.
Receiver Rear Panel
NOTE: Control signal ground pins may be labeled as or “G”. Audio ground pins may
be labeled as or .
The wiring and function are the same, whichever way your product is labeled.
A
Power connector — Plug the included external 12 VDC power supply into this 2-pole
captive screw connector.
ATTENTION: Before wiring the connector, read the notes, attentions, and
warnings in the
Power Supply Wiring and Grounding
section on the next page.
B
Input connector — Connect one end of the TP cable from the transmitter or from the
buffered output connector of an RL receiver to this RJ-45 female connector.
C
Buffered output connector — Connect one end of a TP cable to this female
RJ-45 connector. Connect the opposite end of the same TP cable from the receiver
to the Input RJ-45 female connector on another receiver (see
on page 14 to wire the RJ-45 connectors).
ATTENTION: Do not connect these devices to a computer data or
telecommunications network.
D
Output video connector — Connect a projector or other high
resolution video device to this 15-pin HD connector.
NOTES:
•
The video auto detection feature is sensitive to video signals with high levels,
over-peaked signals, or both, which may result in video detection issues.
•
Input only sync signals (no video signals) on the sync pins (13 and 14).
•
For component video, use the R (R-Y) and R return pins (pins 1 and 6),
G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B return pins
(pins 3 and 8). For S-video, use the R, R return (C-chroma) (or B, B return [see
S-Video switch of
K
on page
]), G, and G return (Y-luma) pins.
•
For composite video, use the G pin and the associated return pin. For additional
genlocked video signals, use the R, B, and associated return pins.
E
RS-232 connector — Connect a serial communications port to this 3.5 mm, 3-pole
captive screw connector for bidirectional RS-232 communication. Wire the connector
as shown in figure 5 on page
.
5
1
15
11
6
10
Female
MTP 15HD RS Series • Installation and Operation
11