Extron Electronics MPS 112_112CS User Guide - Manual (Page 34)

Programmer’s Guide, cont’d
MPS Series • Programmer’s Guide 5-6
PRELIMINAR
Y
Special functions
Switcher mode select
Select switcher mode X7 *1# Mod X7 X7 = switcher mode:
1 = Single mode (default).
2 = Separate switcher mode.
View switcher mode 1 # X7
Mic talk-over threshold
Display talk-over threshold X8 *2 # Thr X8 Shows the mic threshold
number.
X8 = 0 through 15,
default = 8.
Decrement threshold -*2# Thr X8 Decremenst mic threshold one
step.
Increment threshold +*2# Thr X8 Increments mic threshold one
step.
View mic talk threshold 2 # X8
2 = talk-over threshold
X8 = Value range: 0 - 15 (8 = midrange = default)
+ = increment 1
- = decrement 1
Follow sub mode*
Turn the follow sub mode on/off X3 *4# Fsm X3 X3 : 0 = off, 1 = on
View the follow sub mode status 4# Fsm X3 X3 : 0 = off, 1 = on
Mic (phantom) power*
Turn mic power on/off X3 *57# Mfp X3 X3 : 0 = off, 1 = on
View mic power status 57# Mfp X3 X3 : 0 = off, 1 = on
Program audio ducking level in talk over mode*
Adjust audio ducking level X12 *58# Adl X12 Adjusts how much
(
X12 = 0 to 30 dB) the program
audio ducks (automatically
decreases) while the MPS is in
talk over mode.
0 = audio ducking is off.
Increment audio ducking +*58# Adl X12
Decrement audio ducking -*58# Adl X12
View audio ducking level 58# Adl X12
Program audio breakaway*
Switch program audio X1 * X2 $ Pra X1 * X2 Selects any input from any
group to be routed to the
program audio output.
X1 = group 1 through 3
(1 = VGA, 2 = S-video,
3 = composite video).
X2 = inputs 0 through 4 for each
group (input 0 = off).
This command works only in Separate mode with Follow sub-mode turned off. If Follow sub-mode is turned on or if
the switcher is in Single Switcher mode, the program audio breakaway command does not work, and the response is
an E10 error code.
* These groups of commands are new for units using firmware version 1.10 or higher. Earlier firmware
versions do not support these four command groups.
Command ASCII Command Response Description
(host to switcher) (switcher to host)
Switcher-
initiated
messages
X
X
X
X
X