beautypg.com

Preliminar y, Front panel operation, Input selection in single switcher mode – Extron Electronics MPS 112_112CS User Guide User Manual

Page 19: Input selection in separate switcher mode, 3 mps 112 series • operation, Switcher mode controls, Controller)

background image

3-3

MPS 112 Series • Operation

PRELIMINAR

Y

Switcher Mode controls

12

Separate Switcher mode —

This is the secondary function of this button.

Press and release this button while pressing and holding the Mode button (

14

)

to select the Separate Switcher mode. The associated LED indicates if the
Separate Switcher mode is on (when lit) or off. When the Mode button is
released, the LED resumes input indication.

13

Single Switcher mode —

This is the secondary function of this button. Press

and release this button while pressing and holding the Mode button (

14

) to

select the Single Switcher mode. The associated LED indicates if the Single
Switcher mode is on (when lit) or off. When the Mode button is released, the
LED resumes input indication.

14

Mode —

Press and hold this button for more than 2 seconds to view the

switcher status. It also allows mode and setting changes when used in
combination with other buttons, as previously indicated.

Front Panel Operation

Figure 3-2 — MPS switcher front panel

The functions of the front panel controls are described in the following sections.

Input selection in Single Switcher mode

In Single Switcher mode the switcher emulates one switcher with 12 inputs. In this
mode, when one of the inputs is selected, the input is routed to the outputs (video
and audio) for that group, and the audio is sent to the program audio output as
well. All of the other outputs are muted.

When you select and press an input button in Single Switcher mode, the green LED
indicator to the right of the button lights steadily. All of the other LEDs turn off. To
select a different input, press a different input button.

The Extron IR 102 Universal Handheld Remote Control can be used with an
MPS 112 switcher only when the switcher is in Single Switcher mode.

The MPS 112 must be in Single Switcher mode if it is to be slaved to an
Extron MLC (Medialink

Controller).

Input selection in Separate Switcher mode

There are three input selection groups on the front panel: VGA/Audio,
S-video/Audio, and Video/Audio. These groups correspond to the three
independent A/V switchers (in Separate Switcher mode) available in the MPS 112.

Each of the input selection groups has four numbered input selection buttons
(1 through 4), which allow you to choose from among the four separate input
sources in that group that the switcher can output.

All outputs of the three groups are active, but the audio from only one group is
routed to the program audio output. That group (input) is indicated by a flashing
LED, while the other two groups are indicated by solid LEDs. See the Program
Audio
section in this chapter for more details.

MPS SERIES

MIC

PROGRAM AUDIO

VIDEO / AUDIO

S-VIDEO / AUDIO

VGA / AUDIO

VOLUME

VOLUME

MUTE

4

3

2

1

4

3

2

1

4

3

2

1

MIC POWER ON/OFF

MIC VOL RESET

PROG VOL RESET

SEPARATE

SINGLE

MODE

EXEC.MODE

MIX

MEDIA PRESENTATION SWITCHER