In1776qzx s – Extron Electronics IN1776QZX User Manual

Page 11

IN1776QZX OPERATION MANUAL - REV 1.4 11/27/99

The PAL version is sold in the UK, Australia, Germany, Denmark and other countries using the
PAL video standard. PAL versions of the IN1776QZX are marked on the rear panel with a
sticker indicating “

PAL

.”

PERATING THE

IN1776QZX S

CAN

ONVERTER

FRONT PANEL CONTROLS / INDICATORS

The IN1776QZX front panel has only one button (POWER) as virtually all picture adjustments
are controlled by the infrared remote control. Indicator lights on the IN1776QZX front panel
show the current status of the unit.

POWER Button / Power LED
The Power button turns the IN1776QZX on or off. Press lightly on the raised green button to
activate the power. The Power LED will light or go dark, indicating whether the IN1776QZX is
on or off. The Power LED operates the same way whether the unit is turned on using the front
panel

POWER

button or the IR remote

PWR

button.

FREEZE LED
The Freeze LED lights when freeze frame is on and goes off when the unit is in normal mode. If
you press buttons on the IR remote control and nothing is happening, check to see if the FREEZE
light is lit on the front panel.

USING THE INFRARED REMOTE CONTROL

The IR remote included with the IN1776QZX controls all picture adjustments up to 50’ away
from the unit. For best remote operation you should be able to clearly see the front panel of the
IN1776QZX when using the remote. The IR remote has dual transmitter LEDs that put out a
very strong signal. In situations where you do not have a clear shot to the front panel, you may
be able to bounce the IR control beam off the ceiling or walls to hit the REMOTE receiver on the
IN1776QZX. This method is not fool proof so it is always best to have a direct line of sight
between the IR remote the front panel of the IN1776QZX.

SELECTING THE DEVICE TO CONTROL

While the IN1776QZX IR remote has the capability of controlling the IN1776QZX as well as
other devices, this manual only covers the use of the IR remote to control the IN1776QZX. The
six buttons at the top of the unit marked

CD, VCR, CBL, IN1776QZ, AUX 2, and TV

determine which device the remote is currently operating. There are two ways to switch the
remote to the IN1776QZX control mode:

#1 - Press the

IN1776QZX

button located near the top end of the remote. or

#2 - Press the

PWR

button. When the

PWR

button is pressed the remote carries out a

macro which sets it to control the IN1776QZX.

If you are pressing buttons on the remote and nothing is happening it is likely that
one of the other device selector buttons (

CD/VCR/CBL/AUX 2/TV

) has been hit.

Just press

IN1776QZ

and the remote will function normally to control the

IN1776QZX.