Extron Electronics IN2116 - Manual (Page 8)

4
IN2116 OPERATION MANUAL - PRELIMINARY 01/21/02 ©1999 - INLINE, INC.
Compatibility
INPUT
The IN2116 will accept high-resolution video signals from virtually any computer that outputs an analog
video signal (VGA, SVGA, XGA, MAC, SUN, SGI and other high-resolution computers) at virtually any
refresh rate. Input signal compatibility parameters are:
Video Signal: Analog RGB Video
Signal Format: RGBHV, RGBS, RGsB*
Horizontal Frequency Range: 30 KHz to 130 KHz
Vertical Refresh Rates: 30 Hz to 120 Hz
* The IN2116 will operate with RGsB input signals. However, the unit will not strip sync
off of the green. RGsB input signals are always output as RGsB (they cannot be output
as RGBS or RGBHV). Also, the horizontal position control will not operate when used
with RGsB input signals.
OUTPUT
The output signal of the IN2116 is analog RGB video with TTL sync on 3, 4 or 5 female BNC connectors.
The output format can be set to RGBHV, RGBS or RGsB using dipswitches. This output signal is
compatible with high-resolution data grade monitors and data / graphics projectors.
VGA, MAC, SUN, SGI and other high-resolution workstations operate in several video
modes encompassing a wide range of resolutions and scan rates. Many of the video
signals from the newest models can run as high as 70 KHz or more, with the newest
VGA cards offering an output resolution of 1600 x 1200 (some can even go as high as
1920 x 1080). The data projector or monitor connected to the interface output must be
compatible with the horizontal scan rate and vertical refresh rate of the computer’s
video signal. Please check the documentation for both the computer graphics card and
the data display device to ensure compatibility.