Installation – Extron Electronics IN2116 User Manual

Page 10

Installation

This section offers step-by-step instructions for installing the IN2116 (see Application Diagram on page 7).

1. Set the dipswitches for the requirements of your installation (see Dipswitch Settings on page 9). The

IN2116 factory default output format is RGBHV. If your display device, routing system or cabling
requires a different format, use the dipswitches to change the output signal to RGBS or RGsB as desired.

2. Utilizing the #6 wood screws (included), mount the unit under a conference or boardroom table,

computer workshop, or a podium using the integral mounting brackets. Run the necessary video coax,
power and accessory cables to it.

3. Connect the IN2116 output (5 BNC connectors) to the data display device’s RGB input, using three, four

or five high-resolution BNC cables or a multi-conductor RGBHV, RGBS or RGB "snake". The IN7000
/ IN7100 / IN7200 / IN7300 Series high-resolution cables and the IN8800 Series installation cables are
well suited for this purpose. While making connections, take care to insure that the red output is
connected to the red input, green output to the green input, etc.

4. Connect the accessory cables as required by your installation.

Connect the IN9230 Power Cord (included) to the IN2116. The LED on the front of the unit should
light-up to indicate it is on.

6. Turn the computer and computer monitor off. Disconnect the computer monitor (if present) from the

video output port on the computer.

7. Connect the local computer monitor (if present) to the local monitor output of the IN2116. VGA

monitors will attach directly to the local monitor output. For other types of monitors, use the
appropriate local monitor output adapter cable (see list on page 5). If no local monitor is used, set the
monitor emulation dipswitch to emulate a color VGA monitor or a 13” / 14” MAC RGB monitor (see
Dipswitch Settings on page 9).

8. Connect the output of the computer to the Input of the IN2116 with the appropriate input cable.

Complete the installation by turning the computer and computer monitor on. If required, adjust the
horizontal position control.