Extron Electronics IN9128 - Manual

1-IN 2 -OU T RG BHV D IS TRIB UTION
AM PL IFIE R / LI NE DR
IV ER
3252HR
TM
RE D
GR EE N
BL UE
HO RIZ ON TA L/ CO MP S YN C VE RT IC AL SY NC RE D
GR EE N OU TP UT
IN PU T/
LO OP O UT
BL UE
HO RI ZO NT AL /
CO MP S YN C
VE RT IC AL SY NC
Extron
IN3252HR
RGBHV
Distribution Amplifier
Extron
IN9128
Under-Desk
Mounting Kit
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Kyodo Building
16 Ichibancho
Chiyoda-ku, Tokyo 102-0082 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
68-1087-01
Rev. A
03 05
IN9128 Distribution Amplifier (DA)
Under-Desk Mounting Kit Installation Instructions
Mount the DA using the optional IN9128 mounting brackets as follows:
1 . If necessary, remove the feet from the bottom of the DA.
2 . If the name “Inline” is printed on the DA, remove the
two screws on each side of the DA. Use these screws
to mount the brackets.
3 . Attach the mounting brackets to the DA
using either the four supplied
machine screws or the four
screws removed in step 2.
4 . Hold the DA and brackets against
the underside of the surface to
which you are mounting the DA,
and mark the four screw holes.
5 . Drill four pilot holes, each 3/32" (2 mm)
in diameter by 1/4" (6 mm) deep, at the
marked locations.
6 . Using the four wood screws provided, attach
the brackets under the mounting surface.