Setup guide — extender series, cont’d, Step 4, Step 5 – Extron Electronics Extender Series Setup Guide User Manual
Page 2: Step 6, Step 7, Step 8, Step 9, Step 10, Extron extender akm maap, Connect power and turn the equipment on
Setup Guide — Extender Series, cont’d
68-552-50
Rev. A
02 09
Step 4
Mount all AAPs
into faceplates with AAP openings.
Mount Extender AAP models into wall plates or faceplates.
Installation Cable
Cable
Clamp
Screws or Nails
Wall Stud
#4-40 Nut w/ Captive
Washer
Extr
on
Extender AAP
AAP 102
AAP 102
EXTE
NDER
COMPU
TER IN
AUDIO IN
Extron
Extender AKM MAAP
Line Driver
EXTENDER
AKM MAAP
COMPU
TER IN
AU
DIO IN
#4 - 40 Screws
Step 5
Connect power and turn the equipment on
.
Step 6
Test the system and set the gain switch
. Ensure that all devices
receive power. Check and adjust cabling and gain as needed.
Maximum
Max. peaking
and gain
Medium
– Mid-level
peaking and gain
Normal
Unity
gain
Maximum
Max. peaking
and gain
Medium
– Mid-level
peaking and gain
Normal
Unity
gain
Circuit
board
Faceplate
Maximum
–
Max. peaking
and gain
Medium
–
Mid-level
peaking
and gain
Normal
–
Unity gain
Extender D
(viewed
from front)
Extender WM
Extender WM AAP
(viewed from side)
Extender MK, AKM,
AUS, AAP Models
(viewed from rear)
Step 7
Disconnect power
from all the devices.
Step 8
Mount the line driver
into the electrical box or the body of the HSA. See the
Extender AKM MAAP Installation Guide
, or the appropriate HSA Series user’s manual, if needed.
Step 9
For the Extender D, install the Decora
©
faceplate.
Step 10
Restore power
to the devices.