Extron Electronics DVS 150 - Manual (Page 12)

Installation, cont’d
DVS 150 Installation 2-2
Installation
Rear Panel Features
Figure 1 — DVS 150 rear panel
1 AC power connector — Standard AC power connector attaches the scaler to
any power source from 100VAC to 240VAC, operating at 50 Hz or 60 Hz.
2 Composite video input connector — One BNC female connector for
composite video input.
3 Component video input connectors — Three BNC female connectors for
component (R-Y, B-Y, Y) video input.
4 S-video input connector — One 4-pin mini-DIN female connector for S-video
input.
5 RGB pass-thru connector — One 15-pin HD female RGB connector for input.
The signal from the input device is passed through to the output connectors
without being scaled.
6 Output connectors — BNC female connectors for RGsB (sync on green),
RGBS (composite sync), or RGBHV output.
7 RGB output connector — One 15-pin HD female RGB connector for the
output projector.
8 RS-232/contact closure remote connector — One 9-pin D female connector
that allows you to attach a computer or another device, such as a keypad or
other contact closure device, for remote control of the scaler.
You can install and run two output devices simultaneously, one using BNC
connectors, and the other using the RGB connector.
Installation
Overview
To install and set up the DVS 150, follow these basic steps:
1 If desired, mount the scaler in a rack (see “Mounting the scaler” on page 2-3).
Otherwise, install the rubber feet (see “Installing the rubber feet” on
page 2-3).
2 Turn off power to the input and output devices, and unplug the power cables
from them.
3 Attach the scaler to the input devices and the output devices. See “Cabling”
on page 2-4.
4 Plug the scaler, input devices, and output devices into a grounded AC source.
5 Turn on the input and output devices.
INPUTS
R-Y
50/60 Hz
1
2 3 4
Y
B-Y
H
R
V
G
S
B
VIDEO REMOTE
RGB RGB S-VIDEO
OUTPUTS
1 2 3 4 6
8
5 7
100-240V 0.3A