Extron Electronics DSC 301 HD Setup Guide - Manual

1
Mounting and Cabling
Step 1 — Mounting
Turn off or disconnect all equipment power sources and rack mount the
DSC 301 HD unit with either an optional shelf mounting brackets (RSU 126 or
129, RSB 126 or 129) or optional furniture mounting brackets (MBU 125); see
figures 1 and 2 at right. When rack mounting, an optional rack false face plate
(RFF 052) can be fitted on top of the low profile DSC, improving the overall look
within the rack.
Step 2 — Connecting inputs
Connect inputs from video sources to the applicable connectors marked “Inputs”:
b Composite video, c RGB, R-Y, Y, B-Y, d HDMI (with or without embedded
digital audio).
Connect inputs from analog audio sources to the TRS inputs
e .
Step 3 — Connecting outputs
Connect a suitable output display device to the connector marked “Output”
(see
f above) for HDMI output with embedded audio.
Step 4 — Connecting control devices
RS-232 — For serial RS-232 control, connect a host computer or control
system to the 3-pole captive screw connector
g .
RS-232 protocol (default values): 9600 baud, 1 stop bit, no parity, 8 data bits,
no flow control.
USB — Connect a host computer or control system to the front panel mini USB
port for configuration and control via Extron Configurator software.
Step 5 — Connecting power
DC power connector — Plug in a 12 VDC, 1A max power source into this
2-pole captive screw connector a.
DSC 301 HD • Setup Guide
The Extron DSC 301 HD Digital Scaling Converter is a scaling product that accepts the most common video signal formats to be
processed, scaled, and output as HDMI. This setup guide allows an experienced user to easily and quickly set up and configure a
DSC 301 HD using step by step instructions. It covers how to perform basic operations using the front panel controls and selected
Simple Instruction Set (SIS
™ ) commands.
NOTE: For full installation, configuration, menus, connector wiring, and operation details, see the DSC 301 HD User Guide, available
at www.extron.com
Universal Rack Shelf
Front false
faceplate
uses 2 screws.
1/2 Rack Width
Front False
Faceplate
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
RFF 052
1.0A MAX
POWER
12V 1
VIDEO RGB/R-Y,Y,B-Y HDMI
DSC 301 HD
AUDIO
2 3
1 RS-232
Tx Rx G
2 3
INPUTS
OUTPUT
REMOTE
1.0A MAX
POWER
12V 1
VIDEO RGB/R-Y,Y,B-Y HDMI
DSC 301 HD
AUDIO
2 3
1 RS-232
Tx Rx G
2 3
INPUTS
OUTPUT
REMOTE
DSC 301 HD
4 3 1 2 6 7 5
Installation
Rear Panel Features
Power and video input connections Output and control connections
a DC power connector
b
Composite video connector
c RGB, R-Y, Y, B-Y via 15-pin HD connector
d
HDMI connector
e
Audio 3.5 mm TRS (tip-ring-sleeve) connectors
f
HDMI connector
g
RS-232 captive screw connector
MBU 125
Mounting Bracket
#8 Screw
(4) Places
Each Side
Mounting Screws
(2) Places
Each Side
Figure 1. Rack mount
Figure 2. Furniture Mount