Command and response table for sis commands, A/v muting, A/v mute modes – Extron Electronics CTR 8 User Guide User Manual
Page 13: Command and response table for sis, Commands
CTR 8 • Remote Communication and Control
8
Command and Response Table for SIS Commands
Command
ASCII Command
(host to unit)
Response
(unit to host)
Additional
Description
Select input
X)
!
Chn
X)]
X)
= input 0-8
View last selected input
!
X)]
Query contact closure status S/s
X@X@X@X@X@X@X@X@]
Least significant input
on far left
Example response:
01000000
]
Contact input 2 is
selected
Unidirectional Serial Data Port
Configure port parameters
Example command:
E
2*
X2%
,n,8,1CP
}
E
2*19200,n,8,1CP
}
Cpn02•Ccp
X2%
,n,8,1
]
n = Parity = None
8 = Data bits
1 = Stop bit
View parameters
E
2CP
}
X2%
,n,8,1
]
A/V Mute Mode
Configure A/V mute mode
EX#
*
X$
MUTM
}
Mutm
X#
*
X$]
View A/V mute mode setting
E
MUTM
}
X#
*
X$]
Other
Information request
I/i
CTR
•
8
]
Request part number
N/n
60‑xxxx‑xx
]
View the part number
Query firmware version
Q/q
x.xx
]
Firmware build (2
decimal places)
Query full firmware version
*Q/*q
x.xx.xxxx
]
View the full firmware
Reset all device settings to
factory
E
zXXX
}
Zpx
]
A/V Muting
The CTR 8 allows A/V muting for a selected input. This feature allows users to press
the selected input button to mute and unmute the audio and video as needed during a
presentation.
•
Press the button once to select an input (Select state)
•
Press the same button again to activate A/V mute (De-select state)
•
Press the button once more to return to the Select state, which selects the input and
unmutes the audio and video.
NOTE:
The A/V mute feature is only triggered by contact closure. SIS input selection (for
example, entering 1! two times) will not trigger the de-select state.
A/V Mute Modes
There are three A/V mute modes, based on the device:
•
Mute mode 1: Mutes switcher input by selecting channel 0
•
Mute mode 2: Mutes video and audio individually
•
Mute mode 3: Mutes video and sync
Mute mode 0 is the normal (default) single state operation. A/V mute is not activated in this
mode.
NOTE:
See the next page for a partial list of Extron switchers that are compatible with
the different mute modes.