Extron Electronics DFX 100 Series User Guide - Manual (Page 10)

DFX 100 • Panels and Cabling 4
a 12 VDC power input — Connect the provided 12 VDC power supply to the front panel
captive screw connectors. When power is provided to the unit but there is no DVI input,
the front panel lights amber.
Back Panel
Power Receptacle
DC Power Cord
Captive Screw Connector
AC Power Cord
Ground
+12 VDC
External
Power Supply
(12 VDC, 1 A )
POWER
12V
1.0A MAX
Figure 4. 12 VDC Power Connection to DFX 100
ATTENTION:
• Always use a power supply provided by or specified by Extron. Use of an
unauthorized power supply voids all regulatory compliance certification and
may cause damage to the supply and the end product.
• Unless otherwise stated, the AC/DC adapters are not suitable for use in air
handling spaces or in wall cavities. The power supply is to be located within
the same vicinity as the Extron AV processing equipment in an ordinary
location, Pollution Degree 2, secured to the equipment rack within the
dedicated closet, podium, or desk.
• The installation must always be in accordance with the applicable provisions of
National Electrical Code ANSI/NFPA 70, article 75 and the Canadian Electrical
Code part 1, section 16. The power supply shall not be permanently fixed to
building structure or similar structure.
NOTES:
• The length of the exposed wires in the stripping process is critical. The ideal
length is 3/16 inch (5 mm). If it is any longer, the exposed wires may touch,
causing a short circuit between them. If it is any shorter, the wires can be
easily pulled out even if tightly fastened by the captive screws.
• Do not tin the wires. Tinned wire does not hold its shape and can become
loose over time.
b DVI-D input connector — Connect a DVI-D source to this male connector.
NOTES:
• Although the cable is terminated with a DVI-I connector, the transmitter is
compatible only with a single link DVI-D signal.
• The DFX 100 does not support HDCP.
When the transmitter is receiving DVI input signal, the front panel LED lights green.