Extron Electronics CTP150CM Setup Guide - Manual

Setup Guide — CTP150CM
Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
68-994-50 A
02 09
W Installation and service must be
performed by authorized personnel
only. These products must be used with
UL approved, grounded electrical wall
boxes.
The Extron CTP150CM is a seven button, contact closure, remote control panel
that emulates many of the front panel functions of the TPT150 switching and
transmission system, and is used to control the switcher remotely. This guide
provides instructions for experienced installers to set up the CTP150CM.
Step 1
Select and prepare a suitable site for mounting the CTP150CM. The unit can
be mounted in wall boxes (must be UL approved), on tabletops, in an in-table
connector bay, or other MAAP-mounting options.
Step 2
Run an eight-conductor cable between the TPT150 and the site where the
CTP150CM is to be mounted.
Step 3
Connect one end of an eight conductor cable to the TPT150 and the other end to
the rear panel of the CTP150CM, as shown below.
GND
PROJ PWR
VOL DN
VOL UP
IN4
IN3
IN2
IN1
CONTACT
CLOSURE
MADE IN USA
GND
PROJ PWR
VOL DN
VOL UP
IN4
IN3
IN2
IN1
CONTACT
CLOSURE
TPT150
Switching
Transmitter
Input 1
Input 2
Input 3
Input 4
Volume up
Volume down
Projector power
Ground
CTP150CM Control Panel
Step 4
Apply power to all devices and test the system.
Step 5
Disconnect power, securely mount the CTP150CM, and reconnect power to all
devices.