Extron Electronics BUC 202 User Guide - Manual (Page 11)

Rack Rail Mounting
100 -240 V 50 /60 Hz
0.2 A MA X
TRI M
1 2
1
2 TRI M
OUT PUT S BU C 2 02
15 18 0 21 3 6 9 12
-15-18 -2 1 -3 -6 -9 -12
15 18 0 21 3 6 9 12
-15-18 -21 -3 -6 -9 -12
1 2 INP UT S
BU C 202
BUC
202
Side of Rack
ZipClip 200
Back of
Rack
Inside of Rack
Figure 7. BUC 202 Rack Rail Mounting
1. Fasten the ZipClip 200 mounting clip to a convenient location on a rack rail using two
rack screws.
2. Insert the bottom of the BUC 202 into the clip, starting with one end.
3. Pivot the other end of the unit toward the clip and press until the BUC 202 snaps into
place.
4. To secure any loose cables and to provide strain relief, attach tie wraps (“zip ties”)
around the tie wrap notches on the BUC 202 and through the anchor points on the
mounting clip.
Tie Wrap
15 9 12
100-2 40V 50 /60 H z 0.2A MA X
1 2
1
2
TRIM
OUT PUT S
BUC 20 2 1 2
INPU TS 15 18
0
21
3 6 9 12 -15 -18 -21
-3 -6 -9 -12
15 18
0
21
3 6 9 12 -15 -18 -21
-3 -6 -9 -12
ATTENTION: Connect and pull the tie wraps until they are secure.
Do not overtighten.
BUC 202 User Guide • Mounting 7